• Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

300 gallon smoker ideas

mike243

Master of the Pit
SMF Premier Member
1,795
591
Joined Feb 25, 2018
Add some metal under the lid then some good latches, the lid will stay in place after a few hot runs and you can add gasket if needed, the 1 I am building I layed down, I cut center to center for the door.
 

Spieg69

Newbie
12
3
Joined Dec 25, 2019
Tack 1 inch flat around the lid and beat into shape if it doesn't bend heat specific areas with torch and shape don't get a large area to hot or it'll warp again. When cutting a door allow to cool in between cuts.
 

Latest posts

Hot Threads

Top Bottom
  AdBlock Detected

We noticed that you're using an ad-blocker, which could block some critical website features. For the best possible site experience please take a moment to disable your AdBlocker.