1st and 2nd Pizza on the BATW

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

tom c

Smoking Fanatic
Original poster
Aug 26, 2011
450
16
Orlando, FL
Well my frist try at Pizza on thr weber the top looks great the bottom was charcoal, so I had to try again.

On the first try I place the charcoal under the stone, not smart, and ended up cracking the stone after taking the pizza off because I didn't put the top of the weber back on. On my 2nd try I place a pan in the center and  the charcoals only around the outside of the weber and it work great.

1st try

128bac4b_2011-10-1022.40.00.jpg


The top look great, trust me the bottom was charcoal.

b6f082ea_2011-10-1022.17.27.jpg


The 2nd try, top look great.

ee5f7d97_2011-10-1123.35.27.jpg


and the bottom.

39b1e089_2011-10-1123.35.46.jpg
 
Last edited:
I had the same problem with the first couple of pizza's I made also. Then I found out if you keep the grill temp around 350. The stone gets hot enough to draw the moisture out of the crust, but not burn it to a crisp. About 1/2 to 3/4 chimney of charcoal spread around the outside is plenty.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky