Toggle sidebar

Wheels

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Remove the Ads for LIFE - 50% Off!
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
rdknb

rdknb

Master of the Pit
Original poster
OTBS Member
SMF Premier Member
Jan 23, 2010
3,981
159
Chester (Kent Island), Md
I hope to finish my UDS tomorrow and do a test smoke. My question is I was thinking of putting caster wheel on the bottom, then I wondered if it would be too hot for the hard plastic wheels?

Any thoughts?
 
You must log in or register to reply here.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Similar threads

Smokin Okie
Cherry syrup on baby backs ?
Replies
38
Views
2K
Pork
Smokin Okie
Smokin Okie
BigBryanSr
Advice on smoking bone-in ribeye's on Reverse flow offset
Replies
11
Views
641
Messages for All Guests and Members
BigBryanSr
BigBryanSr
apn73
PID & Fan Recommendations For UDS Build
Replies
4
Views
2K
UDS Builds
Fraser
Fraser
M
Wooden smokehouse with pellet burner
Replies
0
Views
524
Smoke Houses
Malaki86
M
KBFlyer
First Sourdough Bread From My Starter
Replies
3
Views
349
Breads
JLeonard
JLeonard
C
Brisket travel and timing dilema
Replies
3
Views
844
Beef
tallbm
tallbm
S
How would you complement Pulled pork in apple juice?
Replies
9
Views
337
Sauces, Rubs & Marinades
JLeonard
JLeonard
I
Exhaust plenum design question.
Replies
4
Views
386
Other Builds
irvin78787884
I

Latest posts

Hot Threads

Top Bottom
Back
Clicky