Thank You johnmeyer

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

6GRILLZNTN

Master of the Pit
Original poster
OTBS Member
SMF Premier Member
Sep 12, 2018
3,257
2,590
Murfreesboro, TN
I want to give John a HUGE Thank You for sending me one of his 3D printed anti-flap attachments for my Chef's Choice slicer. This little gizmo pretty much cured my huge gripe about these slicers. The pic is halfway through a 2 lb pork belly after a couple of hours in the freezer. ZERO flap. I used to always have to flip whatever I was slicing around to minimize the flap. Not any more. Once again, Thanks John!

Dave
IMG_0357.jpg
IMG_0358.jpg
 
  • Like
Reactions: pc farmer
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky