Newb building his 1st RF smoker with ?????

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

wreched75

Newbie
Original poster
Feb 15, 2017
1
10
Hey Guys, 

So i just got started with my RF and i made cuts to my propane tanks and i believe they are off. I had 2 cylinders to it was kind of difficult to get the proper sq in. According to feldon calculations show 12.67 sq in. So what i did was just take length x width to get the sqin (which ended up being 2" h x 7"w) but i just went straight down vs making it curved like half moon shaped, I think i might of screwed up but hey its my first build so ill just make due. Is it an issue that its a tad bit wider? 

Another question of mine is what about the opposite side of the firebox how big is that gap suppose to be? should it also be 2 x 7? Im just hoping i didnt screw up this whole build because of my calculations!!. Sorry i dont have any pics right now ill try to get some later. Thanks in advance!!
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky