1. Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

New near Milwaukee

Discussion in 'Roll Call' started by jeepsteve92xj, Nov 27, 2013.

  1. jeepsteve92xj

    jeepsteve92xj Newbie

    Hey hey.

    New to this forum.

    I have a super cheap Brinkmann vertical charcoal smoker. Modified with felt gaskets around the doors, some aluminized corrugated cardboard joist reflector material on the three closed sides and top to help keep the temp stable. A Weber grill wok charcoal pan with 1/4-20 SS bolts for legs.

    I did a couple Boston Butts, and they were very good. That was unmodified smoker, I only used the oem door gauge and charcoal pan, temps all over the place. They had maybe 4 hours of smoke, and then sat on the gas grill to finish.

    I am going to try to do a low and slow picnic tonight, and then a whole turkey for dinner tomorrow. I'm adding a welding blanket to the insulation layers. It is supposed to be down around 10°F again tonight. New Maverick dual probe thermometer to use.

    Wishing I had ordered a vertical turkey stand, but no time left.

  2. gary s

    gary s SMF Hall of Fame Pitmaster OTBS Member

    [​IMG]Hello and welcome from East Texas. This is a great site, lots of information and great people that are willing to throw in their two cents worth on about anything  ........



  3. scootermagoo

    scootermagoo Smoking Fanatic

    Good luck with the cold and wind we have been having........winter sucks!