New here to the forum. Just finished building a brick smoker. And was looking for a little advise. I fired it up yesterday for a test run. Seems to produce good smoke with good cross over to the smoke box, but seems the heat may be too low. I was wondering if I need to seal up around the smokebox door for heat retention. Any Ideas?
New here
- Thread starter Kboggs
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
Welcome from NJ, I don't know much about that set-up as I'm still green wood to the Smoking world. But this group is full of knowledgeable people. I'm sure you will get your answer!
Wurstmeister
Smoking Fanatic
kruizer
Master of the Pit
Welcome to the forum from NorCal! Sorry, I don't have experience dealing with this kind of smoker... I am sure someone will chime in...
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Spammer PMs, Anybody Else?
- Started by chilerelleno
- Replies: 65
- Blowing Smoke Around the Smoker.
-
Lost my dad yesterday
- Started by normanaj
- Replies: 40
- Blowing Smoke Around the Smoker.
-
On the Edge of Trying Sausage Making
- Started by BrianGSDTexoma
- Replies: 35
- Sausage
-
Took a stroll this afternoon
- Started by Buckeyedude
- Replies: 33
- Field and Stream
