New 500 gallon RF trailer build
- Thread starter eightysecond
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
kam59
Smoking Fanatic
Got my door seals on this weekend, I ended up notching the inside with the plasma so my less than perfect welds weren't on the outside.
I didn't get a picture of the finished product but will take some more soon.
I didn't get a picture of the finished product but will take some more soon.
maple sticks
Smoking Fanatic
kam59
Smoking Fanatic
Hinges have been tacked on after I corrected some minor gaps on a couple door corners... now on to the firebox.
Air intakes complete (minus handles and minor grinding) and door almost done, I used 1/2" X 1" flat bar on the door to make it more rigid.
Ignore where the door says "Bottom", it was late and beers were involved.
Ignore where the door says "Bottom", it was late and beers were involved.
You said "less than perfect welds" earlier in the post.The close up pic of the weld on the firebox looks like a machine did it!
Firebox is welded up and ready for the cuts to it this week.
Bill
Thanks man, I have had a lot of practice on this but not all are that great I assure you.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Featured My first smoked sausage
-
Vacuum sealing juicy stuff
- Started by whistlepig
- Replies: 21
- Slicers, Grinders, Tools, Equipment
-
Cornell Chicken Thighs
- Started by bill ace 350
- Replies: 20
- Poultry
-
Smoker Purchase Suggestion
- Started by bpacilio59
- Replies: 20
- Roll Call
