I took apart my MES to check the connectors and I noticed the element was caked with burnt stuff. I was wondering how to clean it without damaging it. Will a degreaser work or oven cleaner work with out damage? Thanks guys.
MES Element
- Thread starter beretta92_fs2003
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
- Feb 3, 2009
- 5,316
- 139
The heating element ?
If it's the element i just cleaned mine w/ a steel woll pad while i hac it out of the unit.
if its the connectors go ahead and replace them while you have it apart. Also replace the 2 wires that lead to the e;ement w/ 12 guage wire and new high temp connectors,
If it's the element i just cleaned mine w/ a steel woll pad while i hac it out of the unit.
if its the connectors go ahead and replace them while you have it apart. Also replace the 2 wires that lead to the e;ement w/ 12 guage wire and new high temp connectors,
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Our Second piece of Heaven, Little piece on the Atlantic Ocean
- Started by DRKsmoking
- Replies: 48
- General Discussion
-
Getting to the bottom of what happens to cure in smoked sausage
- Started by hog warden
- Replies: 31
- Food Safety
-
Non fat dried milk
- Started by hog warden
- Replies: 31
- Sausage
-
How Do I Get Rid of These Armadillos?!!
- Started by seenred
- Replies: 27
- Blowing Smoke Around the Smoker.
