annaceil
Newbie
Just received my smoker-not out of box yet. Began to think about assembly-how much assembly is there on this Masterbuilt Electric smoker? Looks like a lot from the online manual!
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
MES 40" -how much assembly?
- Thread starter annaceil
- Start date
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Howdy, Anna! Welcome to the Smoking Meats Forums from Texas!
I've had my MES long enough that I don't remember how much is required to get it ready for use, but it was not bad.
Of course, I've reached the age where I can hide my own Easter Eggs, too!
:yahoo:
I've had my MES long enough that I don't remember how much is required to get it ready for use, but it was not bad.
Of course, I've reached the age where I can hide my own Easter Eggs, too!
:yahoo:
It's not bad, Anna----Good directions & only need one tool---Phillips Screw Driver. (Plus a scissors or knife to cut ties & open things).
Be careful---I could see it falling on it's face if you aren't careful opening the door before you put the bottom parts on.
Bear
Be careful---I could see it falling on it's face if you aren't careful opening the door before you put the bottom parts on.
Bear
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
- Featured
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
