Masterbuilt Rewire for auber pid

[bszum2]

Anybody ever rewired a newer masterbuilt smoker to run an auber pid. I have a two black wires, a red, and a white. Trying to figure out what wires need to be wired together for the auber to take over.
Thanks

 

[JLinza]

Im no sparky but I would think.
Red=hot
White= common
2 black=switch (on/off)
But I don't know that for sure. I'd wait for someone with more knowledge to respond. Also pictures might help of where you are trying to land these wires.

 

[912smoker]

Anybody ever rewired a newer masterbuilt smoker to run an auber pid. I have a two black wires, a red, and a white. Trying to figure out what wires need to be wired together for the auber to take over.
Thanks

Several here can help and tallbm can help. JC in GB

Keith

 

[normanaj]

MES Rewire Simple Guide - No Back Removal Needed!!!

Lately I've seen a number of posts about guys wanting to rewire their MES. I had wanted to post a quick and simple guide for those out there that are curious or those that simply need to rewire but need a little assistance. Well here goes. Disclaimer: When messing with electrical equipment...

www.smokingmeatforums.com

 

[zwiller]

normanaj Beat me to it! B bszum2 Throw up some pics. Wire color is only part of it. Make sure you can ID the "braided" wires. Those go to the element.

 

[JC in GB]

Several here can help and tallbm can help. JC in GB

Keith

If you can add some pics of the controller screw terminal labels and the heating element on your smoker, I can likely help you with the wiring.

JC

 

[bszum2]

Here is the cord pictures and the second photo is the heating element wiring. This is is my second smoker and have decided to try an use this one instead for my pid

 

[chopsaw]

I think that's the one that you just have to bypass using the plugs in the harness .
normanaj