Masterbuilt Electric Charcoal Smoker.

[Rings Я Us]

Yep.
Basket with charcoal and wood chunks goes right on the chip pan.
I'm going to do a chuck roast using duel fuel and see how that goes. The electric should keep it steady. Will do a thread this weekend. :D

 

[motocrash]

Onto something here! Some briquettes to get the wood chunks smokin' and even electric heat.Yeah man;)

 

[Rings Я Us]

Onto something here! Some briquettes to get the wood chunks smokin' and even electric heat.Yeah man;)

Probably run at 500° because of 1/2" gap around the heat shield.

 

[tallbm]

Hey let us know if you end up getting any smoke ring color from the charcoal burning.
I thought I read somewhere that you could such a thing to occur using charcoal chunks in an AMNPS. You are effectively doing something similar.

Also I may try to get my hands on some pecan shells and smash them up and burn in the AMNPS and see if they produce a smoke ring :)

 

[motocrash]

Probably run at 500° because of 1/2" gap around the heat shield.

Choke it off with twisted up foil or something.

Also I may try to get my hands on some pecan shells and smash them up and burn in the AMNPS and see if they produce a smoke ring :)

I have a lot of hickory nuts and shells.Hmm

 

[Rings Я Us]

Could do the ECB stacked on the ECM.

 

[motocrash]

Could do the ECB stacked on the ECM.

HAH! The neighbors will think you're building a Rocket/WMD with the cord attached :eek:

 

[Rings Я Us]

I just need something to go inside to keep them together. But of wire on the rack holders .. all 3 match up pretty well inside on both smokers.

 

[motocrash]

Seems easier to just block off some air in the ECM...

 

[Rings Я Us]

Seems easier to just block off some air in the ECM...

Yes. Easily foiled with an aluminum foil pizza pan . They have them at the GFS store. Just trim it and rest it on the heat shield. Or when I foil the shield I can leave extra around the edge to scrunch in the gap