• Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

Masterbuilt dual fuel and wood chip questions

harryset

Fire Starter
32
10
Joined Mar 15, 2013
When cooking with propane, I have tried putting the chips in the OE supplied pan, and also using the frying pan on top of the OE pan.

OE pan use, and I get flareups, put the chips in the frying pan on top of the OE pan and I have to raise the smoker temp to get any smoke at all.  I tried covering the pan with tinfoil and poking with holes, but had only limited success with that, but am still experimenting with it.
 

themule69

Epic Pitmaster
12,888
349
Joined Oct 7, 2012
When cooking with propane, I have tried putting the chips in the OE supplied pan, and also using the frying pan on top of the OE pan.

OE pan use, and I get flareups, put the chips in the frying pan on top of the OE pan and I have to raise the smoker temp to get any smoke at all.  I tried covering the pan with tinfoil and poking with holes, but had only limited success with that, but am still experimenting with it.
It is hard to get wood chips to burn at low temps. Buy a AMNPS and get lots of smoke and you don't have to add chips every half hour or hour.


Happy smoken.

David
 

amorpork

Newbie
3
10
Joined Apr 2, 2013
I have the same smoker and I have to make sure I presoak the wood chips for at least an hour before smoking. I also purchased a stainless steel wood chip box. This box has helped tremendously on the flare ups. I hope this helps. 
 

worktogthr

Master of the Pit
OTBS Member
SMF Premier Member
2,928
1,029
Joined Nov 3, 2013
I just started smoking with this smoker and I found that a cast iron pan on top of the stock chip pan works well... You may have to crank the heat a little at the beginning to get the chips smoking but then you can turn it down to your desired temp and add your meat to the smoker. Cast iron retains heat really we'll so when I added chips throughout the rest of the cook I didn't need to crank up the heat to get smoke. Hope this helps!

Chris
 

randy k

Newbie
20
10
Joined Sep 2, 2013
I have a Master built as well, I got rid of the stock pan and use a cast iron skillet (place on two 1/2" x 1/2" square bars).

But that's not enough for mine it's hard to generate smoke at lower temps. so I bought two 6" AMN smoke tubes, and now it works great for me.

Hope that helps.

Good luck
 

ballplayerlc

Fire Starter
31
10
Joined May 30, 2014
I've had this smoker for about a month and have already used it easily 20+ times. I kept the stock pan in there because I use it for charcoal. I use the propane to fire it up and get the smoker going. But instead of using wood chips, look into wood chunks. I soak them for at least 30 mins before hand but they last a lot long than chips and give a richer smoker flavor in my opinion.
 
Last edited:

nadekow

Newbie
22
10
Joined Jul 13, 2014
I lined the bottom of the stock pan pan with ceramic briquettes to help more evenly spread the heat. I then use a disposable pie pan offset from the center for the wood chips. Spray the bottom of the pie pan with non stick cooking spray and it's easily removable.with a set of tongs if I need to add more.wood.
 

Latest posts

Hot Threads

Top Bottom
  AdBlock Detected

We noticed that you're using an ad-blocker, which could block some critical website features. For the best possible site experience please take a moment to disable your AdBlocker.