OK.. so I am playing around with a Watlow PID controller and an MES 30... The original controls have quit working, plus I want more precise control of temps...
What I am trying to figure out is... can the existing thermocouple in the MES be used with the PID ? If so what type TC is it so I can set the right configuration in the controller ?
I see the TC in the upper left corner of the cabinet.. but what is the button looking thing on the left side about half way down that is wired into the heating element ? Is that something to stop the temps from going to high ?
Thoughts and comments please....
What I am trying to figure out is... can the existing thermocouple in the MES be used with the PID ? If so what type TC is it so I can set the right configuration in the controller ?
I see the TC in the upper left corner of the cabinet.. but what is the button looking thing on the left side about half way down that is wired into the heating element ? Is that something to stop the temps from going to high ?
Thoughts and comments please....