Gasser going down hill

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

buzzy

Smoking Fanatic
Original poster
OTBS Member
Feb 11, 2007
875
477
Cumberland Co. PA
My smoker was working great this weekend. Now doing a brined spatchcock turkey can’t get temp over 210. Was at 230 before putting bird in. Heading towards hr 4. IT is 131. Should I pull it to put in oven or is it ok to ride out since it hasn’t been injected. Need guidance soon. Thanks in advance
 
Try resetting valve. Turn off. Remove valve and wait a bit. Install and turn on SLOWLY and fire up. Pretty common issue.
 
I got temp of 240 now but what I’m concerned about is the bird not making it to 140 in 4 hrs. Am I making a bad bird or since not injected just brined am I ok
 
Thanks halfsmoked
Was never w/o heat. Just low temps. Undid all connections then hooked back up. Got rack temp of 255 & rising. No concern??? Ride out until 165 IT
 
Good enjoy it.

had that happen at an event someone was helping me and they didn't screw the tank fitting up tight and had low flame.

Warren
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky