30% OFF for INKBIRD Infrared Thermometer Gun!!

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Inkbirdbbq

Master of the Pit
Original poster
Oct 26, 2018
1,688
925
UP to 30% OFF for Inkbird NEW Infrared Thermometer Gun with Double Laser!

Inkbird dropped price to $35.99 (Reg: $39.99)!!! PLUS 20% Page Coupon Box under pricing list!
Deal: $28.79 VS $39.99!

👉-58℉~1382℉
👉DS Ratio 16:1
👉C & F Switch
👉Adjustable Emissivity
👉Fast read within 0.5 seconds
👉High & Low Alarm
👉Multiple uses.


lADPBGKodyBm8lXNASzNA8o_970_300.jpg

7.jpg
6.jpg
5.jpg

3.jpg
 

Attachments

  • 10-1.jpg
    10-1.jpg
    393.9 KB · Views: 27
Lol. The IR gun is showing 299.8 aimed at a pot of boiling water! You can't check boiling water with an IR gun because it senses the condensing water vapor coming out of the pot and is much lower of a temp. It should be in the directions. Also, that stainless steel pot won't give a correct reading from emissivity. Shiny stuff needs a piece of duct tape or similar stuck to the outside to aim at to get the correct temp which also should be in the directions. Funny Inkbird Co.
 
  • Wow
Reactions: forktender
I would think that a piece of duct tape on a pot hot enough to boil water, would make a heck of a mess with melting tape mastic.
 
[/QUOTE]
Anything shiny needs something thin to get a good reading. So if it was the hot pot that the temp was needed from, then a band of paper around the pot.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Similar threads

Clicky