SS freezer build/lots of questions

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

uncle jeff

Newbie
Original poster
Jun 11, 2018
2
0
freezer.jpg
hey all,
so I got an advanco stand up freezer from work. I would like to make it into a cold smoker so I can do all sorts of tasty treats. I am trying to figure out if I want to go old school with a normal wood fire box or if I want to use one of those fancy pellet/puck delivery systems.

first though a little about the freezer.
stainless exterior aluminum interior not sure about the insulation or if I should bother with it being I will only be cold smoking with it all the temp controls work on it can I repurpose them.
actually the compressor is still good too. don't need that though

my plan is to do an off set fire box/pellet thing, whichever I decide. I know a smoke stack is needed should it go at the top or middle

like I said lots of questions.
 
If you are trying to make a cold smoker check out smoke daddy Inc.com for their cold smoker attachments. And since it’s low temp you won’t have to remove foam insulation. Just add a stack to the top. If you’re talking about anything over the 140-150 degree range I would remove all the foam insulation and add fiberglass insulation.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky