We have a Masterbuilt vertical electric smoker. Quite a bit of rust has developed inside.
Is sanding and painting the inside a no-no?
Thanks.
Is sanding and painting the inside a no-no?
Thanks.
Rust inside vertical smoker
- Thread starter jmuenchow
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
kruizer
Master of the Pit
I would not paint the inside of your smoker. Use a stainless dish scrubbie to clean the rust and then keep the inside oiled with a good veg oil between smokes.
That’s kind of what I planned. We neglected it on a patio for a while. Won’t make that mistake again! The rust is that bad, so I’m going to give it a shot. Fingers crossed!!
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Featured Prime Boneless Striploin Steaks on the Q
- Started by DRKsmoking
- Replies: 43
- Beef
-
Your Favorite Way to Use Leftover Smoked Pork Ribs
- Started by Jim_C
- Replies: 21
- General Discussion
