/ Register

  1. Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

running temp probes gen 1 mes 40

Discussion in 'Electric Smokers' started by fordman, Oct 17, 2013.

  1. Oct 17, 2013 #1
    fordman

    fordman Smoke Blower

    Just picked up a new gen one mes 40 wondering how people run there temp probe wires other than the one already installed.
     
  3. Oct 17, 2013 #2
    so ms smoker

    so ms smoker Master of the Pit Group Lead OTBS Member

    Gulfport, MS
     Try running down through the exhaust vent to prevent pressure on the wires.

      Mike
     
  4. Oct 17, 2013 #3
    fordman

    fordman Smoke Blower

    Yeah just wondering if there any other ways I planned on placing a 3" elbow over exhaust to help with the draft
     
  5. Oct 17, 2013 #4
    so ms smoker

    so ms smoker Master of the Pit Group Lead OTBS Member

    Gulfport, MS
      I would still go through.

     Mike
     
  6. Oct 19, 2013 #5
    stovebolt

    stovebolt Smoking Fanatic

    Ozark foothills in Southwest Missouri
      The door seal won't hurt them. I run them out the door opening often, no problems.

    Chuck