damascusmaker
Smoking Fanatic
Made from a $3 silicone spoon rest. Another matching piece on the inside. On my UDS-30. The probes for my new Flame Boss wouldn't fit through the hole I had for the Maverick probes.
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Probe Wire management
- Thread starter damascusmaker
- Start date
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Check out a "cable entrance connector" in the electrical dept. at Lowe's. They are only a couple of bucks and have a rubber grommet inside to protect the probe wires. I have never had a problem with mine. Several of the custom builders use this.
damascusmaker
Smoking Fanatic
Cool Joe, If I had known I bet it would have been easier. Next time.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
