OK Joe Mod question

[jimmismoking]

I was told by a few people to take a look at Horizon Smoker website to pick up a tuning plate to help control the heat flow. I sent them an email just to get some general information about the products they sell. They never answered back.

I measured the inside of my smoker and it's 40 in from side to side. The tuning plate I think I need is http://www.horizonbbqsmokersstore.com/servlet/the-335/Convection-Plate--dsh--For/Detail

Of course since the dimension are shorter I just wanted to be sure.

Thanks

 

[chavr904]

I bought one from them and yes not good on reply emails I bought one for the highland model and it fits good my concern for my model is little diffrent tho but I believe it's suppose yo not be the full length of the cooking chamber.

 

[lemans]

Horizon is bad on emails and bad on delivery
But!!!! It's a great product that works
Just be aggressive with your phone calls it will pay off

image.jpg

• lemans
• Jun 15, 2014

 

[jimmismoking]

Thanks guys I appreciate the help.

 

[chavr904]

20140612_091947.jpg

• chavr904
• Jun 12, 2014

Ordered it May 15th and got it June 10th

 

[lemans]

Yours is bent at 90degrees? Mine is at 45!!

 

[chavr904]

Mine is oklahoma joe highland when I went onto the site on horizon it listed that this one fits the highland model so I got it.

 

[lemans]

Very cool

 

[jimmismoking]

That is nice. I want that 45 degree angle though to help any of the drippings sitting at the front of the grill racks to slide down

 

[dockman]

I built my own out of 1/4" plate. No holes in mine and with a few tuning plates it works prefectly.

 

[dockman]

Here is my plate!

 

[jimmismoking]

Nice I had been thinking about that grab a few plates of metal and putting them in place. Do you have them welded in or do they just rest there?

 

[chavr904]

Oh nice

 

[james1nc]

I also have the OK Joe i ordered    horizon, they had to make mine because they were out , they said 3 weeks and it was delivered on time. mine has 45deg angle , but the angle is next to the fire box so it wont help with your drippings from the front of your grill.

 

[dockman]

The plate with an angle next to fire box is welded in. I bolted it first but then figured since I have a welder just as well weld up the gaps. The other plates just lay in place.