Offset with vertical chamber.

[Newbster3000]

Hello all! I’ve been using offset for sometime now and had the opportunity to purchase a used smoker with a chamber. It’s a old Brinkmann when they were built with 1/4 in steel. Any advice is greatly appreciated! Thank you!

 

[mcokevin]

The rust on that makes me hurt, but if it’s 1/4” steel it’s probably ok. Do you know somewhere you can have that rust sandblasted away and the surface refinished? should be good for years with some TLC.

 

[Newbster3000]

The rust on that makes me hurt, but if it’s 1/4” steel it’s probably ok. Do you know somewhere you can have that rust sandblasted away and the surface refinished? should be good for years with some TLC.

Yeah it’s a lot but I think I can use DA sander then use some canola on it when it’s hot. I will post a update picture after reconditioning.