About 50% thru my 250 build and have unusual issue with my CC door. I had to remove a valve at top to position door where I wanted and for some reason it sprung only this location. All 4 corners are flush and bottom center actually sprung in about 1/4”. Hole isnt big enough to get a
Clamp in so im trying figure way to anchor on top side while pushing door down. Ill heat it to let it move more and naturally let it cool so get it back close to flush. Thoughts on how to do
Im not using jack and chain as rest of door in good alignment and dont want to mess it up
Clamp in so im trying figure way to anchor on top side while pushing door down. Ill heat it to let it move more and naturally let it cool so get it back close to flush. Thoughts on how to do
Im not using jack and chain as rest of door in good alignment and dont want to mess it up