My first CHEESE smoke W/Q view

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

cptn jon

Fire Starter
Original poster
Jul 14, 2011
35
11
Manhattan, Kansas, USA
Started my first CHEESE smoke today. I used a tin can with a soldering iron for a smoke generator using cherry wood chips.

Started the process around 8:30A with the ambient air temp of 71 degrees (F) after about 15 minutes the generator was doing a fine job so in went the cheese (a pound each of Colby, Mild Cheddar and Jack). I think they should be done around 12:30P. Then they get wrapped in cling wrap and vacuum sealed for two weeks at least (from all I have read on the subject). I will report the tasting at a later date.

With about an hour and a half left on the smoke I saw the temp get to 90 degrees so I put about ¾ pound of  ice in a tray under the cheese. Hope this will bring down the temp. After 40 minutes with the ice in the smoker the temp dropped 10 degrees and that is a good thing; at this time the ambient temp is 76 degrees. I did not realize that the soldering iron would increase the temp inside the smoker 15 degrees or better. I’ll make sure my next cheese smoke is on a cooler day. I did have to shake the smoke generator 2 or 3 times to keep the smoke flowing. I have found that by having the smoke generator on its side that more attention is needed – (next generator will be vertical).

Overall the smoke went well and the ambient temp was 81 degrees when I pulled the cheese. It is now in the fridge to rest and cure.

4e812616_100_1115.jpg


e13ba058_100_1116.jpg


b6431f0e_100_1117.jpg
 
Great looking cheese! Yep I use the tin can and soldering iron for cold smoking cheese and I found it works better vertical. BF drilled some holes about 1/2 to 34 inch up from bottom, making one large enough to slip the iron it and it works great.
 
Congrats on your first smoked cheese!

Looking forward to cooler temps so I can smoke some cheese and lots of other goodies...
 
Update: After 3 weeks in a vacuum pack, pulled the cheese and had a taste. The wife got the end slice and said it was too smokey for her, but I thought it was excellent. I may have to do some for her on a shorter smoke time say about 1.5 to 2 hours. Everyone else has only been positive in their assessment of the cheese.
 
Your wife should like the middle part of the cheese. I have found that if you cut the cheese into 1/4 lb blocks ,it only needs about 2 - 2.5 hrs of smoke.

We will eat 1/4 lb in one sitting so i don't have to keep opening and re-sealing the pkg.

 Smoking it in one lb blocks the middle ( interior ) will get very little smoke. Also the longer it sits the more it mellows .

We have started letting it age at least 6 weeks before trying it.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky