MES 30" remote control problem model 20070508

[blackcloud]

I need to sync the remote control with my control panal but I cant seem to find my owners manual. The unit is new and it the manual hasn't been posted yet on the MES website. If anyone has a manual handy and could let me know how to do it I would be very thankful. It would be on page 8 if memory serves me.

 

[Bearcarver]

I need to sync the remote control with my control panal but I cant seem to find my owners manual. The unit is new and it the manual hasn't been posted yet on the MES website. If anyone has a manual handy and could let me know how to do it I would be very thankful. It would be on page 8 if memory serves me.

All I do is make sure I start it with the remote, instead of on the top panel.

Mine isn't that model, but I'd think the same. I never had to do any kind of sync.

Bear

 

[blackcloud]

I got a new panel and remote so, I have to sync the two. When your unit is boxed at the factory it is already been done. Do you happen to have the manual handy?

 

[swmo]

I have a new 30 with the remote.  The instructions tell you to contact Masterbuilt at 1-800-489-1581.  There is no mention of syncing in the my manual.

 

[blackcloud]

Thanks. I called earlier toady and they are closed because of the weather until tomorrow.

 

[Bearcarver]

Thanks. I called earlier toady and they are closed because of the weather until tomorrow.

A couple inches is hard on places that aren't equipped to handle it. Might be another day until they open. 

Bear

 

[blackcloud]

Agreed, we just had a storm drop off 13" Christmas night, and its the most snow we have had in my fathers (75) lifetime. We aren't equiped for it either. Made driving interesting. Fortunatly, I smoked 4 turkey breasts and 3 boston butts Christmas day so we didn't starve! LOL

 

[blackcloud]

Got the answer today:

 Link remote and controller by:

a. Turn Controller & Remote “ON”,

b. Press and HOLD “SET TEMP” on controller for 3 seconds.

c. On the Remote press “MEAT PROBE”, “LIGHT”, “MEATPROBE”, “LIGHT” (all buttons must be

pressed within 5 seconds of each other) A short beep will occur after each button press.

 

[Bearcarver]

Got the answer today:

 Link remote and controller by:

a. Turn Controller & Remote “ON”,

b. Press and HOLD “SET TEMP” on controller for 3 seconds.

c. On the Remote press “MEAT PROBE”, “LIGHT”, “MEATPROBE”, “LIGHT” (all buttons must be

pressed within 5 seconds of each other) A short beep will occur after each button press.

Hmmmm---Good to know---Thanks!

Bear