Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
My digital thermometer has a cable running from the probe to a sensor. How does everyone run the cable through the smoker? Just pinch it in the door or drill a hole in the side of the cabinet or what is done?
MoFo I run mine thru the top vent. I am going to put one in the side as soon as get a 1/2" UF water tight connector fitting. But right now I just lay a 2X4 piece on top of mine and put the transmiters on it, they dont get hot that way. Hope this helps out a little...
I use one of the original holes that was in the door, It had some small metal piece riveted to the door. When i removed the nameplate with the built in POC therm, I ended up with some extra holes in the door. I made use of the hole for the original therm and replaced it with an after market unit.
On my charcoal model, I used to run probe wires near the latch, but sometimes they got in the way. Later I found the gap on the hinge side of the door leaves just enough room for probe wires without getting pinched, and they're out of the way too.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.