• Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

galvinized exhauast piping ? is that ok to use

brad455

Smoke Blower
87
24
Joined Jan 10, 2011
iv have a old chimney ven tin my garage and that's a class b vent and was wondering if i can go galvanized exhaust from the smoker to it with out worrying about those nasty fumes of zinc i do not have and galvanized parts in my smoke just the exhaust i would like to user it on ..any suggestions?
 
Last edited:

kc5tpy

Master of the Pit
4,344
184
Joined May 12, 2013
Hello Brad.  So long as you maintain an air flow from your intake to the outlet; which you will do to maintain temp and control the smoke, you will be fine using that galvanised on the exhaust stack.  Good luck.  Keep Smokin!

Danny
 

brad455

Smoke Blower
87
24
Joined Jan 10, 2011
The intake is alum from the mail box mod then out with alum to the galvanized to chimney. Thanks Dan..
 

driedstick

Smoking Guru
OTBS Member
5,980
610
Joined Nov 3, 2011
Local heating dealer had them I think it was like 10-15 dollars and he installed it in the pipe for me. Google 3 or 4" dampers see what you can come up with, I will check also and let you know

Good luck
 

smokeburns

Smoke Blower
136
19
Joined May 7, 2014
I know this is a very old post but I used a galvanised Steele pipe to connect my iq 110 to. I did however put about6 Coates of high temp pain't on it. The pipe does not go all the way to the pit. It stops right at vent. Here is a pic.
 
Last edited:

Latest posts

Hot Threads

Top Bottom
  AdBlock Detected

We noticed that you're using an ad-blocker, which could block some critical website features. For the best possible site experience please take a moment to disable your AdBlocker.