Alright folks. So after talking with several of you over the past few months, gathering a little over 3/4's of the materials and finding sometime to work on it with my buddy, I have finally started my 250 gallon propane tank reverse flow. Now unfortunately I am not the most handy of people and i know even less about metal work, however my buddy(who knows about the same as I) and I are going to construct this smoker with the knowledge and tools at our disposal. We were able to cut the side off of the tank a couple of weeks ago using a cutting torch. The edge are the best but with the grinder it should work out pretty well. And then this past weekend we spent a day working on the doors get them cut hinged and sealed. My plan is loosely based at the moment on Unclebeefs 250 build. However, if anyone knows of any issues related with his or their own I am open to suggestion. Still trying to get the hang of uploading the photos so they are a bit out of order. This is the first time we have welded except for practicing before hand. The trailer is from an old pop up camper.
Last edited: