bridensam
Newbie
Hello everyone,
I am building my first reverse flow and I am looking for ideas for my firebox door. Here is a pic of the firebox. My build is a 24x60 tank with a 24x20x24 firebox.
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Firebox door design
- Thread starter bridensam
- Start date
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Hello everyone,
I am building my first reverse flow and I am looking for ideas for my firebox door. Here is a pic of the firebox. My build is a 24x60 tank with a 24x20x24 firebox.
ribwizzard
Master of the Pit
Just use a flat plate of 1/4" or 3/8" A36, use some 1/2" 0r 3/4" angle and frame in the top and sides of the box to give it more seal. I recomend double plating the top of the firebox with a small air gap between the plates .
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
- Featured
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
