I have a homemade cabinet smoker that's pretty large. I can run 150lbs or more of summer sausage when doing 2-1/2"x20" casings. I smoke only with charcoal. I won't go into a bunch of explanation of the construction of the smoker. My question is a general question about the "meat stall" I've ready about. I typically run a mix of about 60% deer and 40% pork. The pork is typically about 72% lean. The problem I encounter happens whether I'm smoking 2-1/2"x20", 1-1/2"x12' or even 20mm snack sticks. My target temp is 155 internal for all the above. I've run big batches (125lbs) and batches as small as 10lbs. No matter the batch size, when my internal temp appraoches 155, the meat will stall which is not that big of a deal(if it were to just hold around that range). However, instead of holding near that range, the meat temp will drop 4 or 5 degrees very rapidly, again not a big deal. but it doesn't stop there. The batch I'm running today is 10lbs of snack sticks. I had 4 meat probes in vaious areas of the smoker. Got interanl temp to 153 to 157 across all 4. That was at noon. By 1;00 or 1:15 all 4 were back down to 140 degrees internal temp. The charcoal supply has been kept consistent which puzzles me to the next point. When the meat temp starts dropping my smoker box internal temp also drops. I had been holding 175-180 PERFECTLY for a couple hours, always adding a half dozen or so briquettes every 1/2 hour or so so as not to run fuel too low and then have a lag in getting it back up. So, the meat dropped 15 degrees in temp, my smoker got pulled down from 180 to 155 to 160 (that part happened after the meat drop). Note the drop in meat temp happened faster than the smoker temp. Even if I added a 2nd "batch" of charcoal to the smoker it would NOT come back up to tem inside the smoker. I've heard about meat getting to a certain temp and then the stall or breaking down of fatty tissues will commonly cause a stall and even a drop but FIFTEEN degrees????? EVERY time I've run a batch? And how can it affect the internal temp of the smoker so much, especially with only a 10lb batch in there today? I can be patient waiting on the meat to do its thing but it's frustrating to not understand how i can't keep the smoker temp up when my firebox has been kept consistent throughout. If the same amt of charcol was holding 180 how can it suddenly not even be able to hold 160?. That baffles me. So, has anyone else experienced a similar large dip in both meat and smoker temps who also smokes a similar mixture of deer & pork? My results are always amazing but I'd sure like to understand what's going on so.
