Cutting round end caps

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

thx1138

Newbie
Original poster
Oct 18, 2014
13
10
Melbourne, Australia
Guy's,

What is the most common way of cutting your side end caps out of plate steel if building a smoker using pipe instead of tanks? what is the most common used tool for this

Cheers,

Phil
 
Here is a link to a build using pipe. The guy was quite ingenious making his rounded end. There are a couple of ways shown there. The second one is the one I am talking about, but the first one works also.
http://www.smokingmeatforums.com/t/166551/20-pipe-rf-smoker
Geothermal built a smoker out of pipe and the end product looks like an antique tractor!! Realy cool thread!
 
Last edited:
  • Like
Reactions: thx1138
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky