Cheap insulation for firebox

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

PassTheFlux

Fire Starter
Original poster
May 3, 2019
44
6
Hello all,

I have a Dyna-glo wide body, and it goes through a basket of coal (even with the minion method) in approximately 2-3 hours. I have a feeling that if I can insulate the firebox I will be able to get another hour or so out of those charcoals. I have already put high heat res glue around the whole smoker and insulation on the doors. What would job suggest I use as a cheap insulation on the outside of the firebox?

Thanks!

Pass
 
I am going to try some welding blanket as it seems I can prob cover the whole thing for less than 50$ will let you know how it goes!
 
I've used a welding blanket on my last two vertical smokers. They work great but are a little 'ugly'.

What is a good alternative for insulating the walls of the smoker? I already seal the gaps, add fire brick, etc.

Is there a good source for something like ceramic insulation with a backing material ?

Thanks,
Steve
 
I am sorry it has taken me so long to reply. Been busy and got caught up in life. There are my base bars that where modified to my specifications by a eBay welder. He did a great jobs son was fast shipping. Also is my finished welders blanket job. Not the greatest look but I am really hoping it helps.
 

Attachments

  • D9B4C9B5-09D6-4ED1-8902-428AC44D6D92.jpeg
    D9B4C9B5-09D6-4ED1-8902-428AC44D6D92.jpeg
    155.9 KB · Views: 180
  • 370B472D-C442-44C2-9E97-37F20BFEC6A1.jpeg
    370B472D-C442-44C2-9E97-37F20BFEC6A1.jpeg
    185.9 KB · Views: 189
  • 38CFC885-1812-47BD-932C-C2540F353FA8.jpeg
    38CFC885-1812-47BD-932C-C2540F353FA8.jpeg
    154.7 KB · Views: 183
  • C08E47C1-2D21-4CCA-9D0F-8E69E2FB6405.jpeg
    C08E47C1-2D21-4CCA-9D0F-8E69E2FB6405.jpeg
    157.4 KB · Views: 184
Hello,

Would you mind sharing the cost of the bars and the contact information for the welder? It hadn't dawned on me to have them custom built.

Steve
 
So I got the snake bars from a welder on eBay named “top notch welds.” I bought the pair and then messaged him with the specific size and width. With the dynamic-glow firebox being a bit small I wanted the width smaller and there to be more room to snake around. Honestly I can not recommend him enough. There is the link to his bars.

https://www.ebay.com/itm/Minion-Sna...708131?hash=item4203823ba3:g:QDsAAOSw8PJcCvrq
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Great deal on LEM Grinders!

Latest posts

Hot Threads

Clicky