Cheap insulation for firebox

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

PassTheFlux

Fire Starter
Original poster
May 3, 2019
44
6
Hello all,

I have a Dyna-glo wide body, and it goes through a basket of coal (even with the minion method) in approximately 2-3 hours. I have a feeling that if I can insulate the firebox I will be able to get another hour or so out of those charcoals. I have already put high heat res glue around the whole smoker and insulation on the doors. What would job suggest I use as a cheap insulation on the outside of the firebox?

Thanks!

Pass
 
I am going to try some welding blanket as it seems I can prob cover the whole thing for less than 50$ will let you know how it goes!
 
I've used a welding blanket on my last two vertical smokers. They work great but are a little 'ugly'.

What is a good alternative for insulating the walls of the smoker? I already seal the gaps, add fire brick, etc.

Is there a good source for something like ceramic insulation with a backing material ?

Thanks,
Steve
 
I am sorry it has taken me so long to reply. Been busy and got caught up in life. There are my base bars that where modified to my specifications by a eBay welder. He did a great jobs son was fast shipping. Also is my finished welders blanket job. Not the greatest look but I am really hoping it helps.
 

Attachments

  • D9B4C9B5-09D6-4ED1-8902-428AC44D6D92.jpeg
    D9B4C9B5-09D6-4ED1-8902-428AC44D6D92.jpeg
    155.9 KB · Views: 158
  • 370B472D-C442-44C2-9E97-37F20BFEC6A1.jpeg
    370B472D-C442-44C2-9E97-37F20BFEC6A1.jpeg
    185.9 KB · Views: 162
  • 38CFC885-1812-47BD-932C-C2540F353FA8.jpeg
    38CFC885-1812-47BD-932C-C2540F353FA8.jpeg
    154.7 KB · Views: 157
  • C08E47C1-2D21-4CCA-9D0F-8E69E2FB6405.jpeg
    C08E47C1-2D21-4CCA-9D0F-8E69E2FB6405.jpeg
    157.4 KB · Views: 155
Hello,

Would you mind sharing the cost of the bars and the contact information for the welder? It hadn't dawned on me to have them custom built.

Steve
 
So I got the snake bars from a welder on eBay named “top notch welds.” I bought the pair and then messaged him with the specific size and width. With the dynamic-glow firebox being a bit small I wanted the width smaller and there to be more room to snake around. Honestly I can not recommend him enough. There is the link to his bars.

https://www.ebay.com/itm/Minion-Sna...708131?hash=item4203823ba3:g:QDsAAOSw8PJcCvrq
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky