Brisket over mesquite w/ Qview

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

headdungsmoker

Fire Starter
Original poster
Jun 4, 2012
32
10
Calgary, AB Canada
Hi all, am getting ready for some BBQ competitions next month so am doing a few more test runs of various things.  Yesterday did a 10lb brisket.  Rubbed with a basic rub of pepper, garlic and a few other things.  Smoked for about 10 hrs using maple hardwood charcoal and a few sticks of mesquite to internal temp of about 165, than foiled and went another couple hours. Was 200 IT when taken off. Wrapped in towels and in the cooler for another hour to rest.  The results are below.  

a5aced49_IMG-20120715-00326.jpg


Fresh 10 lb brisket, AAA Alberta Angus

305f9178_IMG-20120715-00327.jpg


Rubbed!

e2afd2e6_IMG-20120715-00329.jpg


1st peak, about 8 hrs in.

05f08c12_IMG-20120715-00331.jpg


Removed the point - this got made into chopped beef brisket.

676c5c92_IMG-20120715-00332.jpg


And here's the flat.

6bbe3af1_IMG-20120715-00333.jpg


1st few slices off the flat.

b89a6f05_IMG-20120715-00334.jpg


Other view....

178e8942_IMG-20120715-00335.jpg


Cut most all of the flat all up into slices.

39897038_IMG-20120715-00337.jpg


And the rest info chopped beef brisket - I tend to prefer this over sliced.

73017f5c_IMG-20120715-00339.jpg


A few meals worth ready for the freezer.

I haven't done all that many brisket, but this one came out quite well in my opinion. Very tender, juicy, nice amount of bark and really good beef taste without being overpowered by spices. Smoke flavor fairly mild as well as I didn't use all that much mesquite.  Hope you enjoy the show!

Kevin
 
Nice looking flat, was it very moist?  I am still trying to get the moist flat mastered-I think I will have to go with the foil.

For the point you should try some burnt ends.
 
Great looking brisket.  Make sure for the comps, you trim all the fat off the top of the flat portion so that you don't end up with any fat on the top of your turn in slices.  Really helps with presentation and scores.  It will also allow the rub to both permeate the meat better and help in building the bark.  Good luck!
 
Looks good. I go 14 hours unless putting in cooler then 12. I don't wrap in foil but nothing wrong with it especially if the flat gets too dry. 
 
Brisket freezes very well. just make sure to wrap it in plastic wrap tightly then foil.
 
Brisket and pork both freeze very well.  I usually either vacuum seal of just plain old ziplock freezer bags.  I have never left it in any longer than 2 months, so I am not sure of the shelf life.   
 
Cabrego, not dry at all. Very moist.  I'm sure the foiling helps with that. I also had a water pan in the bottom of the smoker, and didn't trim the fat cap at all.  

Bruno994 - yes, I didn't do any trimming on this one as I was mainly working on the cooking vs. presentation. That said, I need to do more reading on the presentation aspects since this is my first time. Thanks for the tip about trimming the fat on the flat portion. As you can see it definitely limited the smoke penetration on that side and after I scraped off the remaining fat after cooking it wasn't the prettiest in the world. 

JimF - I can't really tell any difference when freezing.  I always put a little of the juices in the container with the meat.  When taking it out of the freezer and heating up again for sandwichs, etc., it is never dry and tastes pretty much like fresh.  

Burnt Ends - yeah I suppose I should try making more of those from the point.  As far as the competition, does adding those really add points in a competition?  I know they are good, but I thought the main focus on the sliced meat from the flat. 

Kevin
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky