Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Hi all, today is the day! I have a 18 lb turkey in my mini. At the 1 1/2 hour mark IT is at 90 degrees. Mini is cruising at 240 with all vents wide open. I may pull the clay diffuser and put in the steamer plate to get the temp up a bit.
Pulled it out at 160. While it looks good. Skin was very rubbery and the meat was a bit too. It tasted great and very moist, I can do better next time.
That's a large mass of cold meat for the mini. Anytime I do something large like that in the mini I'll ramp the temp up a good 30 degrees above my targeted out temp. It's been my experience that's how much it's going to drop once the meat is in there. I think you did good starting with the clay diffuser in. I say that because it appears you had the bird standing on a lower rack position. Had you gone with the steamer or without for the entire smoke you might have risked burning the lower portions of the bird. The largest turkey I have done in the mini was 12 pounds, whole it for on the upper rack and I did use only the diffuser. Ran the mini at 325. Skin was not quite crispy, but not bad.
I did not brine since it already had a solution. I used a poultry rub that I had in my cabinet. I did inject with creole butter.
I do recommend going with a smaller bird that was the smallest one I had so I figured I would give it a shot. I just wanted to see what the mini could do. I am pretty sure the upper part of the chamber runs hotter than down at the base as the top of the bird was a little over cooked.
As far a being moist the juices poured out when I cut it open Also the skin was very rubbery. My propane smoker does a better job because I can crank the heat up in that.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.