• Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

Recent content by stolps

  1. stolps

    Thick cut chops!

  2. stolps

    Thick cut chops!

  3. stolps

    Thick cut chops!

  4. stolps

    Thick cut chops!

    Had my butcher cut me some 1 and 3/4 inch chops. Out them on the smoker at 180 degrees with hickory after brining them. They turned out amazing!
  5. stolps

    Fred Flinstone would be proud

    Pulled them off. Here is the finished product. They are resting. Can't wait to dig in!
  6. stolps

    Fred Flinstone would be proud

    I got nervous if they would turn out or not.....so I threw a slab of spares on. Just in case.
  7. stolps

    Fred Flinstone would be proud

    Picked up a a couple of plates of short ribs. Each plate has 3 bones in them. The 16 ounce beer can is for reference. I coated them in a simple salt and pepper rub. I feel with beef there is no need for too many extra flavors. Out them on the smoker at 285 degrees and will be spritzing them with...
  8. stolps

    Cold weather hints?

    One thing I do to help retain heat inside my smoker, and to reduce the use of extra fuel (no getting around this 100% in cold weather smoking, you are going to burn more fuel regardless) I wrap my smoker in a water heater blanket.  It really helps against the wind and the cold weather.  This...
  9. stolps

    That Sweet Bark

    I have a Big Horn. I run my brisket and pork butts at around 225 to 250. I previously was smoking on a UDS at the same temps and would get real thick bark. Now i am not getting as much and was just wondering if this was common with pellet units or operator error
  10. stolps

    That Sweet Bark

    Hi all. I have a question regarding my wood pellet smoker. Since I have started using it I have noticed that I am not getting as much bark on my cooks as I would like. The food is still tasting great but is lacking that desired outer texture. Has anyone else had issues with developing bark on a...
  11. stolps

    Injected Pork Butt with Q-View

    I tried a few new techniques with this butt. I used my normal rub and then wrapped in plastic wrap and let it sit in the fridge for 24 hours, something I have never tried before but will do from now on. An hour before the smoke, I took it out of the fridge and got my smoker ready. About 11pm...
  12. stolps

    CSR with injection

    before, with injection.after: with a side of slaw, smoked baked beans and grilled stuffed jalapenos.
  13. stolps

    CSR with injection

    That's really good to know. I will use that from now on. I did cook them to an IT of about 160. Have to admit I was worried until I got into them. Thanks for the advice!
  14. stolps

    Brisket - Best & Worse

    best thing to do is keep a log. Write everything you did in a notebook from the rub to the wood used temperature you cooked at and how long, even the weather. It will help you start to fine tune your variables for cooking great consistent BBQ
  15. stolps

    CSR with injection

    I'm fairly new to the BBQ world and am loving it. Yesterday I thought I would try something, I picked up a pack of rib cut CSRs and used an injection on them. I let them sit over night and rubbed them down 4 hours before I threw them in the smoker. I sprayed them with the left over injection...
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Back
Top
Clicky