-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Recent content by michael ark
-
boykjo's reverse flow build 05/07/2015 update
Looks great . Love the saw .- michael ark
- Post #95
- Forum: Reverse Flow
-
-
-
Gravity Feed Reverse Flow Vertical Smoker Build
Looks great! Will be a sweet smoker.- michael ark
- Post #2
- Forum: Other Builds
-
WearEver Proofer smoker build
You will get more draw with a pipe.- michael ark
- Post #5
- Forum: Other Builds
-
Vertical Propane Tank Smoker Build
Were did y'all get the gas burrner set up? Looks great!- michael ark
- Post #14
- Forum: Other Builds
-
-
Picked up this gem for $25! Needs a little work!
Did you wear a mask? Cause you robbed him. Good find!- michael ark
- Post #2
- Forum: Roll Call
-
A little bit of every thing.
It's the only time my water pan is empty .I put on high and get it up in the 370f 400f range and load it up .You load it quick as possible.I have a small piece 3/4 plate steel as a heat sink in the back.Then you just have to watch it from their.Outside temps mater humidity matters your dealing...- michael ark
- Post #3
- Forum: Sausage
-
A little bit of every thing.
pepperoni garlic hot dogs polish sausage dogs in ice water bath. smoked pizza Cherry was used on all. Thanks for looking.- michael ark
- Thread
- Replies: 6
- Forum: Sausage
-
PEPPERONI HELP
Look up bearcarver's uncase pepproni. Can't get much easier than that. Its good too.- michael ark
- Post #2
- Forum: Sausage
-
To inject or Not inject: That is the question
I love injecting.you can do so many things.- michael ark
- Post #9
- Forum: Blowing Smoke Around the Smoker.
-
boykjo's reverse flow build 05/07/2015 update
Keep chipping away. Loks good.- michael ark
- Post #43
- Forum: Reverse Flow
-
More power ruff ruff
Are you haveing problems with it ? Most gosm have a problem on thee low end not the top. I had my stock up to 500f without the water pan. With the jet burrner i had it their with it. yes i put it back to stock since.You will use more gas if you change it.- michael ark
- Post #2
- Forum: General Discussion
-
Craig's list find, I think I hit GOLD!!!!!
Great find!- michael ark
- Post #15
- Forum: Slicers, Grinders, Tools, Equipment
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
