I have a 20" diameter x 40" long piece of pipe that I had rolled from 1/4" thick cold rolled steel and tacked into place. I have completed the bead on the inside and out of it. Now, before I weld on the end caps I am debating if I should add some crescent shaped bracing pieces to the inside of the cook chamber door to prevent spring back when it is cut loose.
Sound like a good idea or not? I know most guys don't do this, but then again a lot of guys are cutting into propane tanks and can't weld anything from the inside.
Thanks,
Kevin
Sound like a good idea or not? I know most guys don't do this, but then again a lot of guys are cutting into propane tanks and can't weld anything from the inside.
Thanks,
Kevin