- May 5, 2016
- 11
- 10
I am building a smoker out of 20" pipe and using round pipe for the legs. When doing so would I need to cut an angle on the portion of the leg I weld to the smoker? Below is how I plan to make the legs.
You wont necessarily need to cut them at an angle, but more shape them to the contour of the pipe. I'm using 36" pipe on my current build and the pipe is so large that my legs sat almost flush square cut because the contour of the pipe since is so large I didn't have to shape my legs at all. Now when you get the legs set at whatever angle you want them then the bottoms will need to be cut at an angle so you can weld your base plate to them.
Yep. If you look close, and I apologize for the poor picture it gives the angles for a height of 44".