weber lid stack
- Thread starter nklcolt1911
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Tough part is going to be cutting the hole without chipping the porcelain coating - if you get a fine enough hole saw that might work. After that if you flare the inside you should be able to drill a few holes and used pop rivets or screws to hold it in place.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
