UDS problems

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

holyrollersbbq

Newbie
Original poster
Apr 3, 2017
3
10
Huntington, Wv
I just built a UDS this last week and went to season it this weekend I sprayed Pam all through it and lit up the smoker after bout an hour and a half I started noticing the Pam I sprayed leaking out the bolts that I bolted my wheels down with. I don't know how it happened the bolts were so tight they barely fit in the holes so I'm trying to figure out if there is a fix I can do t keep it from leaking! Thank hall in advance
 
I would think that after a few smokes they would seal up on their own.

If not some of that gasket material the guys use to seal up their smoker doors probably would work.

Or until you figure out a fix, a piece of cardboard under the smoker will keep the grease off your patio.

I'm not a builder, but I'm sure one will be along shortly to give you a better answer.

Al
 
Just put a little pizza pan under it
f02b8ba5dda8e28ecb2de9aaa8a12cf6.jpg


Sent from my SM-G920V using Tapatalk
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Great deal on LEM Grinders!

Latest posts

Hot Threads

Clicky