- May 1, 2019
- 25
- 3
just want to make before I weld this I changed my stack from 4” to 6” need 1046 EVS I had two 4” x 42” stacks figured but now thinking one 6” x 37” stack does this seem right or which way would be better?
Smoke stack
- Thread starter Bigmark1127
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.
- May 1, 2019
- 25
- 3
Also can I go with two 6” stacks and keep them 24” tall so I can have smoker in garage when not used?
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Tired, time to relax.
- Started by Quiganomics
- Replies: 22
- Blowing Smoke Around the Smoker.
-
Started on the Outdoor Kitchen
- Started by Texascat
- Replies: 22
- General Discussion
-
Weber
- Started by bigfurmn
- Replies: 22
- Blowing Smoke Around the Smoker.
-
Smoking BBQ in Southern WI
- Started by PowerChordBBQ
- Replies: 19
- Roll Call
