Reverse flow smoker build help

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

C.D.

Newbie
Original poster
Jul 2, 2018
6
0
Id like to build a reverse flow smoker out of a propane tank it is 30"x150' I need help on the opening sizes.
The calculator gives some help but some numbers like exhaust camber size look huge using an 8 " pipe, the FB/CC opening of nearly 3 square feet, makes the half moon shaped opening to high on the side, can I use a rectangle shaped opening and move the FB under the CC a bit to lower the opening?
 
Id like to build a reverse flow smoker out of a propane tank it is 30"x150' I need help on the opening sizes.
The calculator gives some help but some numbers like exhaust camber size look huge using an 8 " pipe, the FB/CC opening of nearly 3 square feet, makes the half moon shaped opening to high on the side, can I use a rectangle shaped opening and move the FB under the CC a bit to lower the opening?
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky