Are the figures/formulas to build a regular offset smoker the same as building a reverse flow smoker? Obviously except for the measurements for the RF plate.
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
Question about building a offset smoker non reverse flow
- Thread starter irvin78787884
- Start date
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
I'm no help to your question but I'll give it a bump.
Thanks
I am going tomorrow for 2 propane tanks.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is a community of barbecue and outdoor cooking enthusiasts dedicated to smoking meat.
© 2004-2026 SmokingMeatForums.com
