My offset build (using tuning plates)

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SMF is reader-supported. When you buy through links on our site, we may earn an affiliate commission.

bladebuilder

Meat Mopper
Original poster
I thought I'd share my newest smoker build. I started with a 60 gallon pressure vessel (got from a co-worker who decided a smoker build was more than he wanted to tackle, he had door cut.)
Most parts are recycled steel. The tubing for the legs, and wheels I bought new. Grill is also from scratch. Used stainless gas tubing. Tuning plates (not shown) are 3/8' x 6" wide
smoker1.jpg smoker2.jpg smoker3.jpg smoker8.jpg smoker9.jpg smoker10.jpg smoker11.jpg smoker12.jpg smoker13.jpg smoker14.jpg smoker15.jpg
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Hot Threads

Clicky