Gen 2 MES 40" back.

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

hooligan8403

Meat Mopper
Original poster
Oct 25, 2011
248
11
Montgomery Al
Ok I saw they had returned to Sams Club after being pulled and we all know the problems being had by the early adopters. I sent an email to masterbuilt asking if these smokers were new smokers, refurbished smokers, or just old inventory. According to masterbuilt they were fresh from the factory and all the issues had been fixed. I dont know if I believe them but thought Id pass this along. If you want the exact emails let me know and Ill post them.
 
All I know is that the siliconed replacement controller they sent me was farther off than the one it replaced. I believe the temp sensors are the problem and they are just hoping that keeping moisture out of the controllers will fix them. Problem is they suck without getting wet.
 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Hot Threads

Clicky