• Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.

Dry curing and equilibrium questions

SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
I said earlier that I was going to try corned pork.
Here is my article on corning brines. I use a lot of aromatics for the "corned" flavor verses the "cured" flavor. Some people cut back on the amount of mustard seeds.

 
The Marianski brothers are Polish. .... They do not follow the USDA in Poland.
I didn't realise they were in Poland.
The book is obviously written for an American audience. The frequent reference to US government regulations, and they use US standards of measure rather than Polish standards (I think?)
Explains why they said whether a product needs to be cooked or not depends on where you live.
 
Last edited:
Do a search for porkstrami
Ooh, that sounds good, but I don't have a smoker.
There are some recipes on the interweb without a smoker, but they all disagree as to how it should be cooked.

Some say to simmer the coated meat submerged in water. But wouldn't that wash the rub off?
Other say to roast it uncovered, but comments say this dries the meat too much.
Many say to use a "moist" oven @300F, to build a foil tent to protect the meat from drying. What temperature would the water saturated air inside the tent be?
One said to pressure cook it (250F), wrapped in foil to protect the meat from the moisture.

The last of these appeals most to me, does that sound like a good way to cook it?
 
Last edited:
In this post I am just trying to understand how curing works. There is a lot of contradictory information out there.
I apologise there are so many questions
I have been looking at some older techniques to preserve meat. I have tried to be faithful to the recipes, but this is an amalgam of different recipes. The procedures run like this,
-------------------
daytime temp <50F, rub cure mix into meat and hang.
- salt diffuses into meat
- salt removes water from cells via osmosis
- water diffuses out of meat
- water evaporates

daytime temp >50F, when meat has lost ~10% of its weight
- rub off the cure and hang again
- salt equalizes
- meat continues to dry

daytime temp ~70F, when meat has lost ~20% of its weight, at this point,
- it can be eaten (cooked?*).
- it can be optionally smoked at ~80F,
- it can be aged in the air for months, <95F
------------------

*Some styles can be eaten without further cooking but seem to follow the same procedure to this point, What is the difference that makes it edible without cooking?

In most equilibrium descriptions,
After the cure has been applied the meat is bagged and put into the fridge, allowing 1-2" of thickness per week. Equalization is also carried out in the fridge, not at the higher temperature.

My questions are,
- Are these 'dry curing' procedures really equivalent?
- Does the meat still lose 10% of its weight during curing in the fridge? 20% after equalizing in the fridge?
- Can it be hung in air after curing or equalizing?
- During the cure, the meat will be sitting in its own brine; so is it really a wet brine?

Additional question, Since the 'Dry' cure is sitting in brine, does a 'wet brine' achieve the same result, weight loss and ability to hang etc?

The traditional method makes sense to me, the meat is progressively drying, and is progressively exposed to higher temperatures. Presumably the dryness/temperature combo maintains microbe safety through out the process. But it uses excess cure that must be removed at the correct time.
You’ve raised some interesting questions. My understanding is that dry curing and equilibrium curing work differently, especially regarding moisture loss and temperature control. Food safety also seems to be a major factor. Hopefully, someone with curing experience can clarify these differences.
 
I'm suspicious of "Universal" brines.
I have lots or questions about that article but I'm not sure this is the place to air them.
Here is some history behind Pop's brine. His Father's methods were approved by the New York state inspectors and Pops shared options for small batches of his universal brine.

 
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

Latest posts

Back
Top
Clicky