I use a 16" deflector plate ( Pizza Pan) that has small holes in it. Could this be a problem, or does it matter? I picked it up at Walmart and the holes are only about 1/8 inch.
Deflector plate
- Thread starter megt123
- Start date
-
Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
It's a UDS I built. I don't know if it's a problem. I was just wondering if the plate having holes in it was right or not and since it is only 16 inches will it deflect enough heat in a 55 gallon drum.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Similar threads
Hot Threads
-
Featured Prime Boneless Striploin Steaks on the Q
- Started by DRKsmoking
- Replies: 43
- Beef
-
Your Favorite Way to Use Leftover Smoked Pork Ribs
- Started by Jim_C
- Replies: 21
- General Discussion
