Smoked a brisket that I think turned out pretty darn good. About an 11.5 pound prime from Costco. Maybe around 9 pounds after trimming. Trying some new techniques. Smoked it fat side down for the first time, and did the foil boat after the bark set in. Ran the pit around 250°-275°. It probed tender around 195° or so after only about just under 8 hours. I was so skeptical of that, that I did the boiling water test on both the ThermPro and Thermapen that I have. But, it was true. I also pulled it out then vs waiting to 203° or so.
Rested at room temp for an hour, wrapped in butcher paper, refrigerated overnight, and slowly reheated in the oven then held in the warming oven at 150° the next day. Sliced up around 7 pm. Turned out like so...
I think these techniques worked pretty well. Running the temps higher vs 225°-250°, I think, helps push through "the stall" while preventing too much evaporation and drying of the meat. Any who, very enjoyable.
Rested at room temp for an hour, wrapped in butcher paper, refrigerated overnight, and slowly reheated in the oven then held in the warming oven at 150° the next day. Sliced up around 7 pm. Turned out like so...
I think these techniques worked pretty well. Running the temps higher vs 225°-250°, I think, helps push through "the stall" while preventing too much evaporation and drying of the meat. Any who, very enjoyable.