Bitter taste on skin

  • Some of the links on this forum allow SMF, at no cost to you, to earn a small commission when you click through and make a purchase. Let me know if you have any questions about this.
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.

dannylang

Master of the Pit
Original poster
Smoked a 1/2 chicken and a spatchcocked chicken, waited till my smoker got up to temp, white smoke turned to light blue, before adding the meat. Every time I opened the smoker I would spritz it with white grape juice. Fist time I tried this, will the smoke from the smoker stick to the spritz that I sprayed, used the same oak and hickory that I always use. Pulled off the smoker at internal temp of 168 degrees, just wondering if anyone else has ever had this problem?
 
Smoke has a tendency to stick to wet surfaces. So if your spritzing - well your attracting more smoke. Poultry also takes on smoke rather quickly so you may be experiencing an over-smoked chicken. When I smoke poultry I let it sit in the fridge for a while uncovered to form a pellicle. I personally don't use a lot of wood when smoking poultry because I don't like it overly smokey, and I use a higher heat with no spritzing. I still get a good hint of smoke flavor and crispy skin.

Chris
 
  • Like
Reactions: zwiller
I don't Spritz anything in my Smoker, but I use a well sealed, well insulated electric smoker, so if I would open the door to Spritz, I'd be letting the Hot & Humid air out, and defeating my purpose. Then I'd have to heat it again, after spritzing & closing the door. That could dry out the meat.

When I grill some things, I'll brush marinates or sauces on them, near the end.
Spritzing would be OK here too.

Bear
 
Last edited:
SmokingMeatForums.com is reader supported and as an Amazon Associate, we may earn commissions from qualifying purchases.
Clicky